LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1621 (Transfer Case - Mp 1222/1225/1226-NQG) >> Repair Instructions - Off Vehicle >> Transfer Case Disassemble >> Rear Output Shaft Seal and Bushing Removal

Rear Output Shaft Seal and Bushing Removal

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Output Shaft Seal & Bushing
GM1843577Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Transfer Case Rear Output Shaft Seal
2 Transfer Case Rear Output Shaft Bushing

Procedure

  1. Install the finger section of the J 45380:  remover/installer in front of the bushing.
  2. Install the tube and forcing tube assembly into the finger section. Ensure the forcing screw is backed out.
  3. Using a wrench on the forcing screw, remove the bushing.

Special Tools: 
J 45380:  Transfer Case Rear Bushing Remover and Installer