Access Hole Plugs, Fill and Drain Plug, Lever, Vent, Shift Control Switch, and Vehicle Speed Sensor Installation
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Access Hole Plugs, Fill & Drain Plug, Lever, Vent, Shift Control Switch & Vehicle Speed Sensor
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Access Hole Plugs (Qty: 2) |
| 2 | Transfer Case Oil Fill Plug
CAUTION:
Refer to Component Fastener Tightening Caution
. Tip: Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the oil fill plug before installation. Tighten: 18 N.m (13 lb ft) |
| 3 | Transfer Case Oil Drain Plug Tip: Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the oil drain plug before installation. Tighten: 18 N.m (13 lb ft) |
| 4 | Transfer Case Lever |
| 5 | Transfer Case Control Lever Bolt/Screw
CAUTION:
Refer to Fastener Caution
. Tip: Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) to the control lever bolt before installation. Tighten: 27 N.m (20 lb ft) |
| 6 | Transfer Case Shift Lever Washer |
| 7 | Transfer Case Vent Tip: Apply retaining compound GM P/N 12377901 (Canadian P/N 10953504) to the vent pipe before installation, if removed during disassembly. |
| 8 | Transfer Case Selector Switch - O-Ring - Seal Tip: Lightly lubricate the O-ring with clean DEXRON®VI. |
| 9 | Transfer Case Shift Control Switch Assembly Tighten: 27 N.m (20 lb ft) |
| 10 | Vehicle Speed Sensor O-Ring Seal Tip: Lightly lubricate the O-ring with clean DEXRON®VI. |
| 11 | Vehicle Speed Sensor Assembly Tighten: 17 N.m (13 lb ft) |