Shift Detent Lever Bearing Replacement
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 7079-2
, remove the bearings from the front case half. See Special Tools .
- Ensure the bearings are installed squarely into the bearing bores.
|
| 1 |
Transfer Case Shift Detent Lever Bearing - Inner
Tip:
- Ensure the printing on the bearing is facing upward.
- Install the bearing using the long side of the DT-48215
. See Special Tools .
- Press the bearing until the tool bottoms on the front case half.
Special Tools
- DT-48215
Shift Detent Lever Bearing Installer. See Special Tools .
- J 7079-2
Universal Driver Handle - Non-Threaded. See Special Tools .
For equivalent regional tools, refer to Special Tools . |
| 2 |
Transfer Case Shift Detent Lever Bearing - Outer
Tip:
- Ensure the printing on the bearing is facing upward.
- Install the bearing using the short side of the DT-48215
. See Special Tools .
- Press the bearing until the tool bottoms on the front case half.
Special Tools
- DT-48215
Shift Detent Lever Bearing Installer. See Special Tools .
- J 7079-2
Universal Driver Handle - Non-Threaded. See Special Tools .
|