LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1602 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - Repair Instructions) >> Repair Instructions >> Knock Sensor 1 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Knock Sensor Electrical Connector & Sleeve
    GM1965285Courtesy of GENERAL MOTORS CORP.
  1. If equipped with 4WD, remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
  2. Remove the left front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  3. Working through the wheel well opening, reposition the engine wiring harness sleeve (3).
  4. Disconnect the engine wiring harness electrical connector (4) from knock sensor.
    5. Fig 2: Left Side Knock Sensor & Bolt
    GM1402136Courtesy of GENERAL MOTORS CORP.
  5. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals