Barometric Pressure Sensor Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Barometric Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
1	Bolt CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Retainer
3	Barometric Pressure Sensor Procedure Disconnect the BARO sensor harness connector. Remove the BARO sensor from the intake manifold.