Park Brake Adjustment Verification Check
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Apply and release the park brake lever 3-5 times.
- Install the J-28662: Brake Pedal Effort Gauge to the park brake lever pedal.
- Observe the number of detents required to apply the park brake pedal to the amount of force specified, as indicated on the J-28662:
Brake Pedal Effort Gauge.
Specification: 3-5 detents required to apply the park brake pedal to 500 N (112 lb) of force.
- If the number of detents required to achieve correct force is less than the specification, then the cable tension is too high. Repeat adjustment steps as necessary.
- If the number is detents required to achieve correct force is greater than the specification, then the cable tension is too low. Repeat adjustment steps as necessary.
- Remove the wheel nuts.
- Install the brake caliper and bracket assemblies. Refer to Rear Brake Caliper Bracket Replacement (JD9) or Rear Brake Caliper Bracket Replacement (JH6, JH7) .
- Install the rear tire and wheel assemblies. Refer to Lifting and Jacking the Vehicle .