Rear Axle Shaft and/or Gasket Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Axle Shaft And/Or Gasket

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Axle Shaft Bolt (Qty: 8) CAUTION: Refer to Fastener Caution . Tighten: 156 N.m (115 lb ft)
2	Rear Axle Shaft
3	Rear Axle Shaft Gasket Tip: When installing the NEW gasket, apply a small amount of clean grease to hold the gasket in place while aligning the mounting hole in the axle shaft and the hub.