LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Supplemental Inflatable Restraint System) >> Diagnostic Tests >> DTC B1001: Option Configuration Error >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. If SIR Diagnostic System Check has been performed, go to next step. If SIR Diagnostic System Check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .
  2. Using scan tool, verify PCM is programmed with correct VIN. If VIN is not correct, go to next step. If VIN is correct, go to step  4.
  3. Using scan tool, program correct VIN into PCM. Go to step  9.
  4. If BCM was replaced, go to next step. If BCM was not replaced, go to step  6.
  5. Using scan tool, program BCM to learn restraints identification from SDM. Go to step  8.
  6. If SDM was replaced, Go to step  8. If SDM was not replaced, go to next step.
  7. Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Go to next step.
  8. Using scan tool, reprogram Vehicle Theft Deterrent (VTD) system. Go to next step.
  9. Reconnect all SIR components. Ensure that all components are properly mounted. Go to SIR DIAGNOSTIC SYSTEM CHECK .
scientia non olet · About LEMON Manuals