Removal Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
- Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
- Remove the drive belt. Refer to Drive Belt Replacement .
- Remove the engine wiring harness clip (1) from the air conditioning (A/C) compressor/condenser hose bracket.
- Remove the A/C compressor and condenser hose bracket bolt (2).
- Remove the heater outlet hose clamp bolt (1) at the generator bracket.
- Disconnect the engine wiring harness electrical connector (5) from the generator.
- Reposition the engine wiring harness boot (6).
- Remove the engine wiring harness nut (3) from the generator.
- Remove the engine wiring harness lead (4) from the generator stud.
- Remove the generator bolts.
- Reposition the heater outlet, and AC compressor/condenser hoses as necessary in order to remove the generator.
- Remove the generator from the generator bracket.
WARNING:
Refer to Battery Disconnect Warning
.