Driver or Passenger Seat Back Cushion Frame Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver Or Passenger Seat Back Cushion Frame

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the front seat back cushion cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement . Remove the front seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .
1	Front Seat Back Frame Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten: 50 N.m (37 lb ft)
2	Seat Back Frame Procedure Disconnect the electrical connector, if equipped. The front seat recliner actuator motor is serviced as part of the seat back assembly. If the actuator motor needs to be replaced the entire seat back frame kit will need to be installed. When replacing the seat back frame transfer components as necessary.

Callout

Component Name

Preliminary Procedure

Remove the front seat. Refer to Front Seat Replacement - Bucket .
Remove the front seat back cushion cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement .
Remove the front seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .

Front Seat Back Frame Bolt (Qty: 4)

CAUTION: Refer to Fastener Caution .

Tighten: 50 N.m (37 lb ft)

Seat Back Frame

Procedure

Disconnect the electrical connector, if equipped.
The front seat recliner actuator motor is serviced as part of the seat back assembly. If the actuator motor needs to be replaced the entire seat back frame kit will need to be installed.
When replacing the seat back frame transfer components as necessary.