LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Removal - Right

Cylinder Head Removal - Right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spark plugs from the cylinder head.

    Important:  The cylinder head bolts can NOT be used again. Install NEW cylinder head bolts during assembly.

  2. Remove the cylinder head bolts.
    CAUTION: After removal, place the cylinder head on two wood blocks to prevent damage.
  3. Remove the cylinder head.
    Fig 1: Removing Bolts & Right Cylinder Head
    G02078732Courtesy of GENERAL MOTORS CORP.
  4. Remove the gasket.
  5. Discard the gasket.
  6. Discard the cylinder head bolts.
    Fig 2: Removing Gasket
    G02078733Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals