LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim .
  2. Remove the bolt holding the coolant recovery reservoir and set the reservoir aside.
  3. Remove the oil level indicator.
  4. Remove the screw holding the oil level indicator and the transmission fluid fill tube to the oil fill tube lower support.
    Fig 1: Removing Oil Level Indicator & Transmission Fluid Fill Tube Screw
    G02077902Courtesy of GENERAL MOTORS CORP.
  5. Remove the top half of the oil level indicator tube from the bottom half.
  6. Clean the old sealer from the tube.
    Fig 2: Removing Top Half Of Oil Level Indicator Tube From Bottom Half
    G02077903Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil level indicator tube bolt.
  8. Remove the oil level indicator tube from the engine using a twisting motion.
  9. Clean the old sealer from the oil level indicator tube and the engine block.
    Fig 3: Removing Oil Level Indicator Tube
    G02077904Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals