LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 4.3L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Lifter Installation

Valve Lifter Installation

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply lubricant GM P/N 12345501 (Canadian P/N 992704) or equivalent, to the valve lifter rollers.

    Important:  If reusing the valve lifters, install the valve lifters in the original positions.

  2. Install the valve lifters.
    Fig 1: Installing Valve Lifters
    G02078265Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the valve lifter pushrod guides.

    Tighten 

    Tighten the valve lifter pushrod guide bolts to 16 N.m (12 lb ft).

    Fig 2: Installing Valve Lifter Pushrod Guides
    G02078266Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals