Exhaust Manifold Installation - Right Side

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Right Exhaust Manifold & Gasket

Courtesy of GENERAL MOTORS CORP.

Install the exhaust manifold gasket.
Install the exhaust manifold.

Fig 2: Tightening Sequence Of Exhaust Manifold Bolts (6.6L, LMM)

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the exhaust manifold bolts and nuts.
1. Tighten the exhaust manifold bolts and nuts to 57 N.m (42 lb ft) in the proper sequence.
2. Tighten the center exhaust manifold bolts and nuts an additional pass to 57 N.m (42 lb ft) in sequence.

Fig 3: View Of Exhaust Manifold Heat Shield (Right)

Courtesy of GENERAL MOTORS CORP.

Install the exhaust manifold heat shield.
Install the exhaust manifold heat shield bolts and tighten to 10 N.m (89 lb in).