LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1384 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC O0700 To DTC P3449) >> DTC P2227 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: You must perform the Circuit/System Testing before proceeding with the Component Test.
  1. Ignition OFF, remove the BARO sensor.
  2. Install a 3A fused jumper wire between the 5-volt reference terminal 1 and the corresponding terminal of the BARO sensor.
  3. Install a jumper wire between the low reference terminal 2 of the BARO sensor and ground.
  4. Install a jumper wire at terminal 3 of the BARO sensor.
  5. Connect a DMM between the jumper wire from terminal 3 of the BARO sensor and ground.
  6. Ignition ON, with the J 23738-A  or J 35555  , slowly apply vacuum to the sensor while observing the voltage on the DMM. The voltage should vary between 0-5.2 volts, without any spikes or dropouts.
    • If the voltage reading is erratic, replace the BARO sensor.
scientia non olet · About LEMON Manuals