LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Output Shaft Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Output Shaft Bushing & Special Tools
    GM1217033Courtesy of GENERAL MOTORS CORP.
  1. Install J 44526-2 bolt (8) and J 44526-1 extractor (7) into the bushing (9).
  2. Install J 44526-2 bolt (8) into J 44526-1 extractor (7).
  3. Install the washer (6) and nut (5) onto J 44526-2 bolt (8).
  4. Hold the top of J 44526-2 bolt (8) with a wrench and tighten the nut (5) until J 44526-1 extractor (7) engages the bushing (9).
  5. Install the bearing (3), washer (2), and nut (1) onto J 44526-2 bolt (8).
  6. Install J 44526-3 protector (4) onto J 44526-2 bolt (8).
  7. Hold the top of J 44526-2 bolt (8) with a wrench and tighten the nut (1) until the bushing is dislodged.
  8. Remove the J tools.
  9. Remove the bushing from J 44526  . See Special Tools .
scientia non olet · About LEMON Manuals