LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1337 (Wheel Drive Shafts) >> Repair Instructions >> Front Wheel Drive Shaft Seal Protector Replacement >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Halfshaft Seal Cover Clamps & Nylon Strap
    GM404258Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful when removing the clamps to avoid damaging the halfshaft seal cover.
  1. Use side cutters to cut the halfshaft seal cover clamps (2) and the nylon strap (1).
    2. Fig 2: View Of Halfshaft Seal Cover
    GM211901Courtesy of GENERAL MOTORS CORP.
  2. Slide the halfshaft seal cover (1) off of the halfshaft, over the CV joint end.
  3. Check the halfshaft seal cover (1) for rips, tears, worn spots or other damage. Reuse the halfshaft seal cover (1) if there is no damage visible.
scientia non olet · About LEMON Manuals