LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Engine Controls And Fuel - 6.6L - Introduction (1 Of 2)) >> Repair Instructions >> Fuel Tank Draining >> Fuel Tank Draining Procedure

Fuel Tank Draining Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Fill Pipe Assembly
    GM1378752Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) or Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (With Dual Batteries) .
  2. Remove the fuel fill cap.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Loosen the fuel fill pipe clamp (2).
  5. Remove the fuel fill pipe from the fuel tank.
  6. Insert the J 45004  hose into the tank.
  7. Attach the J 45004  hose to the hose used with the hand or air operated pump devise.
  8. Using a hand or air operated pump drain as much fuel from the tank as possible.
scientia non olet · About LEMON Manuals