LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1305 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Replacement (Extended Cab)

Rear Door Replacement (Extended Cab)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Side Door & Hinge Bolts
GM1829904Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to SIR Warning .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling
  2. Remove the rear door trim panel. Refer to Rear Side Access Door Trim Panel Replacement
1 Rear Side Door Upper Hinge Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Procedure

  1. Remove the water deflector.
  2. Support the door before removing the hinge bolts.
  3. Disconnect the electrical connector, if equipped.
  4. With the aid of an assistant, remove the door.

Tighten:  25 N.m (18 lb ft)

2 Rear Side Door Lower Hinge Bolt (Qty: 2)

Tighten:  25 N.m (18 lb ft)

3 Rear Side Door
Procedure: 
When replacing the door it is necessary to transfer all of the internal components.