LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1298 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Switch Cancel Cam Position Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement .
    2. Fig 1: View Of Steering Column Shaft Assembly Components
    GM1702353Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DISCARD the old steering shaft lock plate ring.
  2. Remove the following parts from the steering shaft:
    1. Steering shaft lock plate retaining ring (1) using compressor J 23653-SIR  and adapter J 42137  . See Special Tools .
    2. Turn signal switch cancel cam position plate (2)
    3. Turn signal switch cancel cam (3)
scientia non olet · About LEMON Manuals