Decal or Stripe Replacement (HYBRID 2 Mode Lower Bodyside Door)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Lower Bodyside Door Decal Or Stripe Location

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Using a J 25070 or equivalent, in a circular motion, remove the old decal from both lower door panels. Remove all adhesives as follows: For metal body panels use a 3M Scotch Brite® molding adhesive remover disc, 3M P/N 07502 or equivalent. For plastic panels use a lint-free cloth with Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and clean drinkable water to remove left over adhesive. For the final preparation prior to application of the new decal, refer to Graphics/Decals/Emblems . Special Tools: J 25070 Heat Gun 500-750°F
1	HYBRID Lower Door Decal Tip: The lower door decal is serviced as one part.

Callout

Component Name

Preliminary Procedures

Using a J 25070 or equivalent, in a circular motion, remove the old decal from both lower door panels.
Remove all adhesives as follows:
- For metal body panels use a 3M Scotch Brite® molding adhesive remover disc, 3M P/N 07502 or equivalent.
- For plastic panels use a lint-free cloth with Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and clean drinkable water to remove left over adhesive.
For the final preparation prior to application of the new decal, refer to Graphics/Decals/Emblems .

Special Tools: J 25070 Heat Gun 500-750°F

HYBRID Lower Door Decal
Tip: The lower door decal is serviced as one part.