LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1260 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (1 Of 5)) >> Diagnostic Information and Procedures >> Cylinder Deactivation (Active Fuel Management) System Diagnosis

Cylinder Deactivation (Active Fuel Management) System Diagnosis

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Active Fuel Management System Diagnosis is applicable for RPO LC9/LY5/LMG/L76.
  1. Measure the engine oil level. Fill, as required.
  2. Using the scan tool, inspect for diagnostic codes within the engine control module (ECM). Refer to Diagnostic System Check - Vehicle (without HP2) or Diagnostic System Check - Vehicle (with HP2) . Repair, as required.
  3. Verify proper engine oil pressure and operation of the active fuel management oil pressure relief valve. Refer to Oil Pressure Diagnosis and Testing .
  4. Verify proper operation of the active fuel management system components. Refer to Cylinder Deactivation (Active Fuel Management) System Compression Test .
  5. Remove the valve lifter oil manifold. Refer to Valve Lifter Oil Manifold Replacement .
  6. Verify proper operation of the valve lifter oil manifold. Refer to Cylinder Deactivation (Active Fuel Management) Valve Lifter Oil Manifold Diagnosis and Testing .
  7. Replace the active fuel management valve lifters, as required. Both intake and exhaust lifters should be replaced in pairs. Refer to Valve Lifter Replacement (LY2, LY6, L92) or Valve Lifter Replacement (LC9, LH6, LMG, LY5, L76) .
scientia non olet · About LEMON Manuals