MP 3023 ATC with 32T Input Spline
WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- The high/low clutch has neutral pointing engagement teeth. The leading edges of the teeth are symmetric.
- The speed reluctor wheel profile thickness is thinner than the MP 3023 ATC with 27T input spline and the MP 3024, measuring 25.8 mm (1.016 in) thick.
- There is no snap ring between the speed reluctor wheel and the rear output shaft rear bearing assembly.
- There is no snap ring groove in the rear output shaft between the speed reluctor wheel and the rear output shaft rear bearing assembly.
- The rear output shaft rear bearing retaining ring is smaller than the MP 3023 ATC with 27T input spline and the MP 3024. The inner diameter of the ring groove at the rear output shaft measures 33 mm (1.299 in).
- The rear output shaft bearing assembly inner diameter measures 35 mm (1.378 in) the width measures 23 mm (0.906 in).
- The rear output shaft bearing assembly surface on the rear output shaft measures 35 mm (1.378 in).
- There is an additional harness bracket.