LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1213 (Anti-Lock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW With TCS & VSES) >> Diagnostic Information and Procedures >> DTC C0186 or C0196 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC C0710 is not set.
  2. Ignition OFF, disconnect the harness connector at the yaw rate/lat sensor.
  3. Ignition OFF for 60 seconds, test for less than 5 ohms between the low reference circuit terminal 1 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance.
  4. Ignition ON, test for B+ between the ignition voltage circuit terminal 4 and ground.
    • If not within the specified range, test the ignition voltage circuit for a short to ground or open/high resistance.
  5. If all circuits test normal, replace the yaw rate/lat sensor.
scientia non olet · About LEMON Manuals