LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Automatic Transmission Servicing (4L80-E)) >> Adjustments >> Shift Cable

Shift Cable

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission shift control lever into park.
  2. Apply the park brake.
  3. Raise and suitably support the vehicle.
  4. Remove the end of the range selector cable from the range selector lever ball stud. See Fig 1 .
  5. Position the transmission range selector lever to park. Rotate the range select lever clockwise until it reaches the full mechanical stop position.
  6. Slide the locking tab retainer to the side.
  7. Release the locking tab.
  8. Install the end of the range selector cable to the range selector lever ball stud.
  9. Engage the locking tab without disturbing the cable. This sets the adjustment.
  10. Slide the locking tab retainer over the locking tab.
  11. Lower the vehicle.
  12. Check the transmission for proper operation.
  13. Release the parking brake.
Fig 1: Locating Shift Cable Adjustment
G00089899Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals