Engine Flywheel Installation (Manual Transmission): Installation

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Place the engine flywheel in position on the crankshaft.
Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.

Fig 1: View Of Tool EN 46106

Courtesy of GENERAL MOTORS CORP.

Install the EN 46106 . See Special Tools .

Fig 2: View Of Flywheel & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the remaining NEW engine flywheel bolts.
Tighten:
1. Tighten the NEW engine flywheel bolts to 30 N.m (22 lb ft).
2. Tighten the NEW engine flywheel bolts an additional 75 degrees using the J 45059 . See Special Tools .

Fig 3: Identifying Clutch Plate Disc, Clutch Pressure Plate & Engine Flywheel

Courtesy of GENERAL MOTORS CORP.

Install the clutch driven plate disc and the clutch pressure plate to the engine flywheel. Ensure to align the clutch pressure plate to the pins in the engine flywheel.
Loosely install the clutch pressure plate bolts.

Fig 4: View Of Clutch Pressure Plate & Clutch Disc

Courtesy of GENERAL MOTORS CORP.

Install the J 33169 through the clutch driven plate disc and into the end of the crankshaft in order to align the clutch driven plate disc. See Special Tools .
Tighten the clutch pressure plate bolts.
Tighten: Tighten the clutch pressure plate bolts to 23 N.m (17 lb ft).
Remove the J 33169 . See Special Tools .

Fig 5: View Of Tool EN 46106

Courtesy of GENERAL MOTORS CORP.

Remove the EN 46106 . See Special Tools .