LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1158 (Engine Mechanical - 3.6L (3 Of 6)) >> On-Vehicle Repair Instructions (2 Of 2) >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Flywheel
    GM902811Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission. Refer to Transmission Replacement (Rear Wheel Drive) or Transmission Replacement (All Wheel Drive) .
  2. Remove the engine flywheel bolts and the flywheel. Refer to Engine Flywheel Removal (Automatic Transmission)  or Engine Flywheel Removal (Manual Transmission) .
  3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection (Automatic Transmission) or Engine Flywheel Cleaning and Inspection (Manual Transmission) . If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if you find excessive wear or damage to the starter drive. Refer to Starter Motor Replacement (LY7) .
scientia non olet · About LEMON Manuals