Dampener and Rear Output Flange Installation

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Dampener and Rear Output Flange

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Rear Output Shaft Seal Dirt Deflector Tip: Replace only if removed or damaged.
2	Transfer Case Rear Output Shaft Flange Assembly
3	Transfer Case Rear Output Shaft Flange O-Ring Seal
4	Transfer Case Rear Output Shaft Thrust Washer
5	Transfer Case Rear Output Shaft Flange Nut NOTE: Refer to Fastener Notice . Tighten: 305-332 N.m (225-245 lb ft) Special Tools: DT-48847 Pinion Flange Holder. See Special Tools .
6	Transfer Case Vibration Dampener
7	Transfer Case Vibration Dampener Bolt Tighten: 27-35 N.m (20-26 lb ft)