New Special Tools Required

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Injector remover J-37281-A is used with a slide hammer to remove stuck injectors from the cylinder head.
Injector seal installer and sizer EN-48266 is used to load the compression seal on the end of the injector tip and then size it to the injector bore.
Injector bore and sleeve cleaning kit EN-47909 consists of two brushes, a T-handle and over-sized swabs used to clean the injector bore.
HP Fuel Pump Installation Alignment Gage EN-48896 is used to eliminate HP fuel pump damage due to incorrect installation.
Camshaft retaining tools EN-48383 (-1, -2, and -3) are used in conjunction with camshaft locking tool EN 46105 (-1, -2) for correct installation of the camshaft timing drive system.