Static Test
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the high pressure fuel pump.
- Test for 0.49 ohm plus/minus 0.023 ohm of resistance at 20°C (68°F) between FRP regulator low circuit terminal 1 and FRP regulator hi circuit terminal 2.
- If not within the specified range, replace the high pressure fuel pump.
- Test for infinite resistance between each terminal and the high pressure fuel pump housing/case.
- If not the specified value, replace the high pressure fuel pump.