LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Automatic Transmission Servicing (4L60-E)) >> Removal & Installation >> Shift Cable >> Removal

Shift Cable: Removal

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake. Position the steering column shift lever to Park. Remove the knee bolster trim panel.
  2. Remove the clip securing the shift cable to the steering column bracket. Remove the shift cable from the steering column shift control. Pull back the carpet and insulation to gain access to the shift cable pass-through grommet.
  3. Remove the rubber grommet from the floor panel. Raise the vehicle. See Figure .
  4. Remove the shift cable from the stud ball. Remove the locking clip from the cable at the bracket. Unclip the cable from the retainers at the fuel lines and body. Lower the vehicle. Remove the cable from the vehicle.
scientia non olet · About LEMON Manuals