LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Automatic Transmission Servicing (4L60-E)) >> Removal & Installation >> Control & Shift Solenoids >> Removal

Control & Shift Solenoids: Removal

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not remove the valve body for the following procedure. Removal of the 1-2 accumulator is necessary only if servicing the pressure control solenoid.
  1. Remove the transmission oil pan and filter. See DRAINING & REFILLING  under LUBRICATION.
  2. Remove the 1-2 accumulator if necessary. See ACCUMULATOR ASSEMBLY  .
  3. Disconnect the internal wiring harness electrical connectors from the following components:
    • Transmission fluid pressure switch. See Fig 2 .
    • 1-2 shift control solenoid.
    • 2-3 shift control solenoid.
    • Pressure control solenoid.
    • TCC PWM solenoid.
    • 3-2 shift control solenoid.
  4. Remove the pressure control solenoid retainer. Remove the pressure control solenoid. See Fig 3 .
  5. Remove the 1-2 and 2-3 shift control solenoid retainers. Remove the 1-2 and 2-3 shift control solenoids. See Fig 4 .
  6. Remove the 3-2 control solenoid retainer. Remove the 3-2 control solenoid. See Fig 4 .
Fig 1: Locating Valve Body Solenoids
G99A03602Courtesy of GENERAL MOTORS CORP.
Fig 2: Locating Control & Shift Control Solenoids
G99A03602Courtesy of GENERAL MOTORS CORP.
Fig 3: Disassembling Pressure Control Solenoid
G00056998Courtesy of GENERAL MOTORS CORP.
Fig 4: Disassembling Shift Control Solenoids
G00056999Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals