LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Automatic Transmission Servicing (4L60-E)) >> Lubrication >> Oil Cooler Flushing & Flow Check >> Preparation

Oil Cooler Flushing & Flow Check: Preparation

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. During the installation of the repaired or replacement transmission, DO NOT connect the oil cooler pipes.
  2. Remove the fill cap (9) on the transmission oil cooler line flusher and fill the flusher tank (4) with 20-21 oz. (0.6L) of flushing solution using the measuring cup (6). See Fig 1 . DO NOT overfill.
  3. Install the fill cap (9) on the flusher and pressurize the flusher tank (4) to 80-100 psi (550-700 kPa), using the shop air supply at the tank air valve (2).
  4. With the water supply valve (1) on the flusher in the OFF position, connect the water supply hose (7) from the flusher to the water supply at the faucet.
  5. Turn ON the water supply at the faucet.
Fig 1: Identifying Flushing Equipment
G00056982Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals