Component Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the door latch assembly.
- Test for infinite resistance between the signal circuit terminal 9 (LHD) or 4 (RHD) and the ground circuit terminal 8 (LHD) or 3 (RHD) with the switch in the open position.
- If not the specified value, replace the door latch assembly.
- Test for less than 2.0 ohms of resistance between the signal circuit terminal 9 (LHD) or 4 (RHD) and the ground circuit terminal 8 (LHD) or 3 (RHD) with the switch in the closed position.
- If greater than the specified range, replace the door latch assembly.
- Test for infinite resistance between each terminal and the door lock key cylinder switch housing/case.
- If not the specified value, replace the door latch assembly.