LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1126 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Turning Ignition Lock Cylinder To RUN Position
    GM874786Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If you are installing a new lock cylinder, refer to Key and Lock Cylinder Coding .
  1. Position the ignition lock cylinder in the run position and insert it into the lock housing.
  2. Rotate the ignition lock cylinder in the housing. Verify proper rotation.
  3. Install the steering column shroud. Refer to Steering Column Shroud Replacement .
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) .
scientia non olet · About LEMON Manuals