LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1115 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Steering Knuckle
    GM1982888Courtesy of GENERAL MOTORS CORP.
  1. Install the steering knuckle (1) to the lower control arm. Refer to Lower Control Arm Replacement (AWD)  or Lower Control Arm Replacement (RWD) .
  2. Install the steering knuckle (1) in the upper control arm. Refer to to Shock Absorber and Spring Assembly Replacement 
  3. Install the brake hose bracket to the steering knuckle retaining bolts. Refer to Front Brake Hose Replacement (RWD) or Front Brake Hose Replacement (AWD) .
  4. Install the outer tie rod to the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement (with Rear Wheel Drive) or Steering Linkage Outer Tie Rod Replacement (with All Wheel Drive) .
  5. Install the wheel bearing/hub. Refer to Front Wheel Bearing and Hub Replacement (AWD)  or Front Wheel Bearing and Hub Replacement (RWD) .
  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals