Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stabilizer Shaft Links

GM874639

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft link to the vehicle.

IMPORTANT:

Do not tighten the nuts at this time.
Hold the shaft link studs with the hex tool to prevent damage to the link seal.

Install the stabilizer shaft link lower retaining nut.

NOTE: Refer to Fastener Notice .

Install the stabilizer shaft link upper retaining nut.
Tighten: Tighten the nuts to 125 N.m (92 lb ft).
Lower the vehicle.