Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Install the tire and wheel assembly.
Hand start the wheel nuts.

Fig 1: Wheel Nut Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Improperly tightened wheel nuts can lead to brake pulsation and rotor damage. In order to avoid expensive brake repairs, evenly tighten the wheel nuts to the proper torque specification.

Using the J 39544-KIT (proper size torque stick), tighten the wheel nuts in sequence. Refer to Fastener Tightening Specifications
Install the wheel center cap, if required.
Install the wheel cap nuts, if required.
Remove the support and lower the vehicle.