Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Frame Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the tower brace. Refer to Cross Vehicle Brace Replacement .
Remove the nut (1) from the top of the engine mount.
Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
Position a screw jack and a block of wood under the engine oil pan.

Fig 2: View Of Right Engine Mount
Courtesy of GENERAL MOTORS CORP.
Remove the right and left engine mount lower nut (1).

Fig 3: Identifying Engine Mount Lower Nut
Courtesy of GENERAL MOTORS CORP.
Using the screw jack, raise the engine enough to remove the engine mount (1).

Fig 4: View of Washers and Engine Mount
Courtesy of GENERAL MOTORS CORP.
Be sure to remove the engine mount slotted washer (1) or plastisol insert washer (2) between the engine mount and the frame.