LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side (W/AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount Lower Retaining Nuts
    GM1067552Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle.
  2. Using the engine support fixture, lower the engine.
    3. NOTE: Refer to Fastener Notice .
  3. Install the lower engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  4. Install the upper engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  5. Install right side front axle shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side .
  6. Install the right engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (w/RWD)  or Engine Mount Bracket Replacement - Right Side (w/AWD) .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals