LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Flywheel Holding Tool
    GM1690147Courtesy of GENERAL MOTORS CORP.
  1. Remove the A/C compressor and power steering pump drive belt. Refer to Water Pump and Generator Belt Tensioner Replacement .
  2. Remove the generator and water pump drive belt. Refer to Air Conditioning Compressor and Power Steering Pump Belt Tensioner Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the transmission bell housing inspection hole cover.
  5. Install the EN-48018  flywheel holding tool as shown. See Special Tools .
  6. Remove the front air deflector. Refer to Front Air Deflector Replacement .
    7. Fig 2: View Of Crankshaft Balancer & Bolt
    GM902878Courtesy of GENERAL MOTORS CORP.
  7. Remove the crankshaft balancer. Refer to Crankshaft Balancer Removal .
scientia non olet · About LEMON Manuals