LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Engine Mechanical - 3.6L (2 Of 6)) >> On-Vehicle Repair Instructions (1 Of 2) >> Air Conditioning Compressor And Power Steering Pump Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering & A/C Drive Belt Tensioner
    GM887771Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt tensioner and bolt to the engine as an assembly.
  2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
    3. NOTE: Refer to Fastener Notice .
  3. Install the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  4. Install the power steering and air conditioning drive belt. Refer to Air Conditioning Compressor and Power Steering Pump Belt Replacement .
  5. Install the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement .
scientia non olet · About LEMON Manuals