LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1110 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the window all the way down.
  2. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  3. Remove the water deflector.
  4. Remove the window inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
  5. Remove the rear side door stationary window. Refer to Rear Side Door Stationary Window and Front Channel Replacement .
  6. Remove the window outer belt sealing strip. Refer to Rear Door Window Belt Outer Sealing Strip Replacement .
  7. Remove the door applique. Refer to Rear Door Frame Applique Replacement .
  8. Connect the door trim panel electrical connector.
  9. Run the window to the full up position.
  10. Tape the window in the up position.
  11. Fig 1: View of Rear Door Window and Frame
    GM758774Courtesy of GENERAL MOTORS CORP.
  12. Remove the rear door stationary window post bolt.
  13. Loosen the window clamp nuts 4 revolutions.
  14. Using the power window switch, lower the window regulator to the full down position.
  15. Remove the tape.
  16. Slide the window down past the window regulator clamps and out of the front window run channel.
  17. Lift the window out of the door.