LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1107 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Fascia and Power Steering Fluid Cooler Assembly
    GM1974067Courtesy of GENERAL MOTORS CORP.
  1. Position the power steering fluid cooler (2) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the power steering fluid cooler bracket bolt (1).

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).

  3. Install the power steering fluid cooler bracket nut (3).

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

  4. Secure the front bumper fascia. Refer to Front Bumper Fascia Replacement .
    5. Fig 2: View Of Power Steering Cooling Lines
    GM1371688Courtesy of GENERAL MOTORS CORP.
  5. Connect the power steering cooler hose to the power steering fluid cooler.
  6. Clean any excess fluid from the vehicle and remove the drain pans.
  7. Install the front air deflector. Refer to Front Air Deflector Replacement .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals