LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1107 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering cooler hose to the vehicle.
    2. Fig 1: View Of Power Steering Cooling Lines
    GM1371688Courtesy of GENERAL MOTORS CORP.
  2. Connect the power steering cooler hose to the power steering fluid cooler.
    3. Fig 2: View Of Power Steering Cooler Pipe/Hose-To-Frame Retaining Bolt
    GM1371689Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the power steering fluid cooler bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 3: View Of Power Steering Cooler Pipe/Hose & Power Steering Lines
    GM1371691Courtesy of GENERAL MOTORS CORP.
  4. Connect the power steering reservoir inlet hose and the power steering gear outlet hose to the power steering cooler hose.
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the front air deflector. Refer to Front Air Deflector Replacement .
  7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals