Windshield Washer Solvent Container Replacement (Minus CE4)

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Washer Solvent Container Replacement (Minus CE4)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement . Drain the windshield washer solvent into a suitable clean container. Disconnect the forward lamp harness electrical connectors from the windshield washer container pump and windshield washer solvent level indicator. Remove the windshield washer container cap. Transfer the component parts as needed.
1	Washer Container Screw (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Washer Container Nut Tighten: 9 N.m (80 lb in)
3	Windshield Washer Solvent Container Tip: Lift the container from the stud on the front compartment panel assembly and lower the washer container from the vehicle.