Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the rear compartment latch striker to the vehicle.
- Install the nuts in order to secure the latch striker to the vehicle.
- Adjust the rear compartment latch striker as necessary.
Tighten: Tighten the latch striker fasteners to 9 N.m (80 lb in).
- Install the rear fascia. Refer to Rear Bumper Fascia Replacement .
- Install the rear compartment sill plate. Refer to Rear Compartment Sill Trim Plate Replacement .
NOTE:
Refer to Fastener Notice
.