Turn Signal Switch Bracket Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turn Signal Switch Bracket Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
1	Turn Signal Switch Bracket Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Turn Signal Switch Bracket Procedure Disconnect any electrical connectors as needed. Release the plastic retaining tabs to release the turn signal switch bracket from the steering column. Transfer any parts as needed.

Callout

Component Name

Preliminary Procedure:
Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .

Turn Signal Switch Bracket Bolt (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 9 N.m (80 lb in)

Turn Signal Switch Bracket

Procedure

Disconnect any electrical connectors as needed.
Release the plastic retaining tabs to release the turn signal switch bracket from the steering column.
Transfer any parts as needed.