LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1096 (Steering Wheel & Steering Column) >> Repair Instructions >> Lower Intermediate Steering Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Secure the steering wheel utilizing a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
  • The steering column
  • The intermediate shaft
  • The steering gear

After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment of some components during installation and result in possible damage to the SIR coil.
  1. Remove the left side engine splash shield. Refer to Engine Splash Shield Replacement .
    2. Fig 1: View Of Steering Column Intermediate Shafts
    GM1198603Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Place scribe marks on the intermediate steering shaft and the lower intermediate steering shaft prior to removal. These marks will be used for the correct alignment during installation.
  2. Remove the intermediate steering shaft bolt (3).
    3. IMPORTANT: Place scribe marks on the lower intermediate steering shaft and the steering gear prior to removal. These marks will be used for the correct alignment during installation.
  3. Remove the lower intermediate steering shaft bolt (4).
  4. Disconnect the lower intermediate steering shaft (1) from the steering gear (5) and the intermediate steering shaft (2).
  5. Remove the lower intermediate steering shaft from the vehicle.
scientia non olet · About LEMON Manuals