LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1096 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower-To-Center Intermediate Shaft Retaining Bolt
    GM1198240Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If a new intermediate steering shaft is being installed then transfer the position of the alignment marks from the old component to the same locations on the new component. Failure to transfer the alignment marks may result in an off-center steering wheel after installation.
    NOTE: Refer to Fastener Notice .
  1. Connect the intermediate steering shaft to the lower intermediate steering shaft.
  2. Install the intermediate steering shaft bolt at the lower intermediate steering shaft.

    Tighten:  Tighten the bolt to 30 N.m (23 lb ft).

  3. Position the lower intermediate steering shaft to the vehicle with the intermediate steering shaft connected.
    4. Fig 2: View Of Upper-To-Center Intermediate Shaft Retaining Bolt
    GM1198236Courtesy of GENERAL MOTORS CORP.
  4. Connect the intermediate steering shaft to the upper intermediate steering shaft.
  5. Install the intermediate steering shaft bolt at the upper intermediate steering shaft.

    Tighten:  Tighten the bolt to 30 N.m (23 lb ft).

    6. Fig 3: View Of Intermediate Shaft Lower Pinch Bolt
    GM907425Courtesy of GENERAL MOTORS CORP.
  6. Connect the lower intermediate steering shaft to the steering gear.
  7. Install the lower intermediate steering shaft bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  8. Install the left side engine splash shield. Refer to Engine Splash Shield Replacement .
scientia non olet · About LEMON Manuals